Panasonic DBS 824 Installation Manual page 410

Appendix 6
Terminal Programming
Resuming
SMDR or Bus Monitor Mode After Terminal Programming
The DBS 824's Serial Interface Unit (SIU) supports three remote functions:
l
Bus Monitor
l
SMDR
l
Terminal (Remote) Programming.
However, only one of these functions can operate at a time. When not in
Terminal (Remote) Programming, either SMDR or Bus Monitor is active.
When you enter Terminal Programming (#99xXxX), the other function stops.
When finished, the SMDR or Bus Monitor function resumes. The DBS 824
can be reset to the desired SMDR or Bus Monitor mode by entering (or
having someone at the site enter) one of the following codes at an extension
or attendant position:
Table B-2.
Codes
for
switching SMDRIBus Monitor modes
Command Function
#90 Normal Bus Monitor on SIU Maintenance Port (CN2)
#91
Register Bus Monitor on SIU Maintenance Port (CN2)
I
#2 1 Poll Bus Monitor on SIU Maintenance Port (CN2)
)
#93 ) SMDR Output on SIU SMDR Port (CNl)
I
Issued 3/l /95 DBS 824-l O-400 B-3