Ftp File Transfer - ZyXEL Communications Prestige 316 User Manual

Prestige 316 Broadband Sharing Gateway / Wireless LAN
2. You have applied a filter in Menu 3.1 (LAN) or in Menu 11.5 (WAN) to block telnet service.
3. The IP you entered in the Secured Client IP field in Menu 24.11 does not match the client IP. If it does not
match, the Prestige will disconnect the telnet session immediately.
4. You have an SMT console session running.

10.6 FTP File Transfer

In addition to uploading the firmware and configuration via the console port and TFTP client, you can also
upload the Prestige firmware and configuration files using FTP. To use this feature, your workstation must
have an FTP client.
When you telnet into the Prestige, you will see the following screens for uploading firmware and the
configuration file using FTP.
To upload the router firmware, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Type "put firmwarefilename ras" where "firmwarefilename" is the name
of your firmware upgrade file on your workstation and "ras" is the
remote file name on the router.
4. The system reboots automatically after a successful firmware upload.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading router firmware using TFTP (note
that you must remain on this menu to upload router firmware using TFTP),
please see your router manual.
You see the following screen when you telnet into Menu 24.7.2.
10-8
Menu 24.7.1 - System Maintenance - Upload Router Firmware
Press ENTER to Exit:
Figure 10-6 Telnet into Menu 24.7.1
Transferring Files