Srx550 High Memory Services Gateway Back Panel - Juniper SRX550 Hardware Manual

SRX550 High Memory Services Gateway Back Panel

Figure 5 on page 38 shows the back panel of the SRX550 High Memory Services Gateway.
Figure 5: SRX550 High Memory Services Gateway Back Panel
1
3
Table 8 on page 38 describes the components on the back panel of the SRX550 High Memory Services
Gateway with reference to
Table 8: SRX550 High Memory Services Gateway Back Panel Components
Number Component
1 Two power supply
slots. Each power
supply contains a
power cord outlet.
One 645 W AC
power supply is
provided with the
services gateway.
2 ACE Slot
3 Grounding point
2
4
Figure 5 on page 38.
Location Description
Left side of The power supply provides
back panel power to the services
gateway and its components.
When the services gateway
is equipped with the two
power supply option, they
work together to provide
redundancy and load-sharing.
The following power supplies
are available:
Top center of NOTE:
the back panel
Left side of the Contains two M5 screws that
back panel you use to connect the
grounding cable to the
services gateway chassis.
5 6
645 W AC power supply
with PoE power
645 W DC power supply
with PoE power
This slot is not used.
Usage
Power supplies are
hot-swappable and support
single- or dual-redundant
power supply versions.
If you need to power off
the services gateway after
it finishes booting, first use
the CLI to halt the device.
Connects the services
gateway chassis to earth
ground.
38