Srx550 Services Gateway Mini-Physical Interface Modules - Juniper SRX550 Hardware Manual

Because the services gateway GPIMs communicate with the backplane at various performance levels, you
must install them in the correct slots.
NOTE: Remove the GPIM adapter before you install double-high, double-wide XPIM.
RELATED DOCUMENTATION
SRX550 Services Gateway Front Panel | 15
SRX550 Services Gateway Power over Ethernet | 9
Installing a Double-High, Double-Wide Gigabit-Backplane Physical Interface Module on the SRX Series
Services Gateway
Physical Interface Modules

SRX550 Services Gateway Mini-Physical Interface Modules

The SRX550 Services Gateway has two slots for installing Mini-Physical Interface Modules (Mini-PIMs).
A Mini-PIM is a network interface card that is installed in the services gateway to provide physical
connections to a LAN or WAN. The Mini-PIMs supported on the services gateway are field-replaceable
units (FRUs); which you can remove or replace at your site. You can install Mini-PIMs into the two Mini-PIM
slots on the front panel of the services gateway chassis.
For more information about supported Mini-PIMs and the minimum supported Junos OS release, see SRX
Series Services Gateway Interface Modules and Compatibility.
For more information about supported Mini-PIMs, including how to install and configure Mini-PIMs, see
the SRX Series Services Gateways for the Branch Physical Interface Modules Hardware
RELATED DOCUMENTATION
SRX550 Services Gateway Front Panel | 15
SRX550 Services Gateway Power over Ethernet | 9
Physical Interface Modules
26
Guide.