Upgrading media modules and devices
Connect the WAN line
To connect a WAN line, see
Configure the WAN line on the G350
Configuration may be performed on site by connecting a laptop computer to the CON port of the
G350, or remotely via a modem connected to the G350 or S8300.
For information about preparing a modem, see
for remote access
the G350
on page 79.
Record WAN information for software configuration
When you add a new WAN line, note the following information for software configuration:
Slot and port number on the Avaya G350 Media Gateway to which the WAN line connects
●
Test the WAN link
After installation of the WAN line is complete, test the link by verifying that the SIG LED for the
port to which the link connects is lit. It is also recommended that you ping the IP address of a
device using the WAN line and perform a trace route test in order to test connectivity with the
network and outside the network.
Adding an Avaya Partner Contact Closure Adjunct
To install an Avaya Partner Contact Closure Adjunct, follow the instructions in
Avaya Partner Contact Closure Adjunct
90 Installation and Upgrades for the Avaya G350 Media Gateway
Step 3: Connect to the Wide Area Network (WAN)
on page 61. For information about configuration, see
on page 59.
Chapter 4: Connecting and enabling a modem
on page 56.
Chapter 5: Configuring
Step 5: Install the