Adding A Wan Line; Order The Wan Line; Connect The Wan Line; Configure The Wan Line On The G250 - Avaya G250 Installing And Upgrading

Adding a WAN line

You must order, connect, configure and test the WAN line before adding the line to the Avaya
G250 Media Gateway.

Order the WAN line

If you need to order the WAN line, make sure that the service provider installs the line near the
physical location of the G250 and verifies that the line is working before you configure the WAN
on the G250.

Connect the WAN line

To connect a WAN line, see

Configure the WAN line on the G250

Configuration may be performed on site by connecting a laptop computer to the CON port of the
G250, or remotely via a modem connected to the G250 or S8300. For information about
preparing a modem, see
page 49.
For information about configuration, see

Record WAN information for software configuration

When you add a new WAN line, note the following information for software configuration:
slot number (2) and port number on the Avaya G250 Media Gateway to which the WAN
●
line connects

Test the WAN link

After installation of the WAN line is complete, test the link by verifying that the SIG LED for the
port to which the link connects is lit. It is also recommended that you ping the IP address of a
device using the WAN line and perform a trace route test in order to test connectivity with the
network and outside the network after you have activated the WAN interface using the CLI.
Step 3: Connect to the Wide Area Network (WAN)
Chapter 4: Connecting and enabling a modem for remote access
Chapter 5: Configuring the G250
Adding a WAN line
on page 44.
on page 57.
Issue 6 November 2009
on
67