With A Pallet Jack; Figure 44: Removing An Ac Power Distribution Module Before Installing The; Figure 45: Removing A Dc Power Distribution Module Before Installing The - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Removing the Power Supply Modules Before Installing an MX2020 Router with a Pallet Jack
88
Figure 44: Removing an AC Power Distribution Module Before Installing
the MX2020 Router
Figure 45: Removing a DC Power Distribution Module Before Installing
the MX2020 Router
To remove the AC or DC PSMs (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
On an AC-powered router, move the AC power switch on each PSM to the off (
2.
position. On a DC-powered router, move the DC power switch on each PSM to the off
( ) position.
O
We recommend this even though the PSMs are not connected to power sources.
Figure 46 on page 89 and
Copyright © 2013, Juniper Networks, Inc.
Figure 47 on page 90):
)
O