Juniper MX2020 Hardware Manual page 438

MX2020 3D Universal Edge Router Hardware Guide
412
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Shut down power to the router by switching the DC circuit breaker for all PDMs to the
4.
off ( ) position.
O
Disconnect power from the router.
5.
Remove the cables that connect to all external devices.
6.
Remove all field replaceable units (FRUs) from the router.
7.
Attach the front and rear shipping covers.
8.
CAUTION: Apply force to any other parts of chassis other than the shipping
covers can damage the chassis.
Remove the router from the rack:
9.
Install the pallet jack attachment to a pallet jack. Position the pallet jack in front of
the rack, and unscrew and remove the mounting screws from the rack.
NOTE: The pallet jack attachment only fits on a standard pallet jack.
The standard pallet jack is approximately 48 in. (121.92 cm) deep x 27 in.
(68.58 cm) wide.
WARNING:
Not using a pallet jack with the attachment can result in personal injury
and can damage to the equipment.
A minimum of four people can then slide the router onto the pallet jack by using the
handles on the shipping covers. Attach the four shipping brackets and hardware to
the pallet jack attachment. Securing the brackets to the router chassis.
Position the router in front of the shipping crate and raise the pallet jack.
Remove the shipping brackets and hardware and set aside.
Place the router in the shipping crate or onto the pallet. If on a pallet, bolt the router
10.
to the pallet.
Re-attach the shipping brackets to the router chassis and the pallet.
11.
Cover the router with an ESD bag and place the packing foam on top of and around
12.
the router.
Replace the accessory box on top of the packing foam.
13.
Securely place the crate cover over the router.
14.
Close all latches to secure the shipping crate to the pallet.
15.
Write the RMA number on the exterior of the box to ensure proper tracking.
16.
Juniper recommends using a pallet jack with the attachment.
Copyright © 2013, Juniper Networks, Inc.