Removing the MX2020 Lower Cable Manager
Copyright © 2013, Juniper Networks, Inc.
Figure 143: Installing the Upper Cable Manager
To remove the lower cable manager (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the two captive screws on the lower cable manager cover, and remove it.
2.
Using a Phillips (+) screwdriver (number 1 or 2), loosen the mounting screws on the
3.
lower cable manager.
Grasp the lower cable manager, and pull it straight out from the studs on the front of
4.
the chassis.
Chapter 13: Replacing MX2020 Router Hardware Components
Figure 144 on page
308):
307