Installing An Mx2020 Cb-Re; Figure 102: Removing A Cb-Re - Juniper MX2020 Hardware Manual

Related
Documentation

Installing an MX2020 CB-RE

Copyright © 2013, Juniper Networks, Inc.
Place the CB-RE on the antistatic mat or into an antistatic bag.
7.
If you are not replacing the CB-RE immediately, install a blank panel over the empty
8.
slot.

Figure 102: Removing a CB-RE

0
Preventing Electrostatic Discharge Damage to an MX2020 Router on page 320
Effect of Taking the MX2020 Host Subsystem Offline on page 228
Taking an MX2020 Host Subsystem Offline on page 230
Installing an MX2020 CB-RE on page 233
To install an CB-RE (see Figure 103 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connec
1.
the strap to one of the ESD points on the chassis.
Remove the CB-RE from the electrostatic bag.
2.
Carefully align the sides of the CB-RE with the guides inside the chassis.
3.
Slide the CB-RE into the chassis until you feel resistance, carefully ensuring that it is
4.
correctly aligned.
Chapter 13: Replacing MX2020 Router Hardware Components
19
235):
233