Copyright © 2013, Juniper Networks, Inc.
To take the MPC offline, see
on page
244.
Issue the following CLI command to take the ADC offline:
3.
user@host>request chassis adc slot slot-number offline
For more information about the command, see the
Command Reference
.
NOTE:
When issuing the
will lose power, and the system total power will increase.
Open the ejector handles outward simultaneously to unseat the ADC.
4.
Grasp the ejector handles, and slide the ADC about halfway out of the chassis.
5.
Place one hand underneath the ADC to support it, and slide it completely out of the
6.
chassis.
Place the ADC on the antistatic mat or into an antistatic bag.
7.
If you are not replacing the ADC immediately, install a blank panel over the empty
8.
slot.
Figure 107: Removing an ADC
0
10
11
12
13
14
15
16
17
18
19
Chapter 13: Replacing MX2020 Router Hardware Components
"Removing an MX2020 MPC from the Adapter Card"
Junos OS System Basics and Services
request chassis adc offline
command, the FRU
247