MX2020 3D Universal Edge Router Hardware Guide
274
Disconnecting an MX2020 DC Power Distribution Module Cable
WARNING:
Before performing DC power procedures, ensure that power is
removed from the DC circuit. To ensure that all power is
breaker on the panel board that services the DC circuit, switch the circuit
breaker to the
OFF
in the
position.
OFF
To disconnect a power cable for a DC PDM:
Switch off the dedicated customer site circuit breaker for the PDM being removed.
1.
Follow your site's procedures for ESD.
Make sure that the voltage across the DC power source cable leads is 0 V and that
2.
there is no chance that the cables might become active during the removal process.
Verify that the
LED on the PDM is not lit.
3.
–48V
Remove the power cable from the external DC power source.
4.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
5.
the strap to one of the ESD points on the chassis.
Remove the clear plastic cover protecting the terminal studs on the faceplate.
6.
Remove the nut and washers from each of the terminal studs. (Use a 7/16-in.
7.
[11 mm] nut driver or socket wrench.)
Remove the cable lug from the terminal studs.
8.
Carefully move the power cable out of the way.
9.
Replace the clear plastic cover protecting the terminal studs on the faceplate.
10.
Connecting an MX2020 DC Power Distribution Module Cable
WARNING:
Before performing DC power procedures, ensure that power is
removed from the DC circuit. To ensure that all power is
breaker on the panel board that services the DC circuit, switch the circuit
breaker to the
OFF
in the
position.
OFF
To connect a power cable for a DC PDM:
Locate a replacement power cable that meets the specifications defined in
1.
DC Power Subsystem Electrical Specifications" on page
Verify that a licensed electrician has attached a cable lug to the replacement power
2.
cable.
Verify that the
LED is off.
3.
–48V
position, and tape the switch handle of the circuit breaker
position, and tape the switch handle of the circuit breaker
Copyright © 2013, Juniper Networks, Inc.
, locate the circuit
OFF
OFF
, locate the circuit
"MX2020
357.