Juniper MX2020 Hardware Manual page 85

Copyright © 2013, Juniper Networks, Inc.
Upper cable manager—MX2000-CBL-TOP-S
Middle cable manager and air filter—MX2000-CBL-MID-S
Lower cable manager—MX2000-CBL-BTM-S
DC power cable manager—MX2020-DC-CBL-MGR-S
The upper cable manager, (see
interface, which has rows for routing and securing the cables away from the front of the
Modular Port Concentrators (MPCs), and Modular Interface Cards (MICs).The lower
cable manager, (see Figure 34 on page
cage, which has rows for routing and securing the cables away from the front of the
Modular Port Concentrators (MPCs), and Modular Interface Cards (MICs).
You can use cable strips or other ties to gently secure the cables in the upper and lower
cable manager. To secure the cables in place, loop the tie through the cable anchor and
secure the tie.
There is one DC cable manager per DC PDM. The DC cable manager routes cables away
from the rear of the PDMs, (see
You can use cable strips or other ties to gently secure the cables in the DC cable manager.
To secure the cables in place, loop the tie through the cable anchor and secure the tie.
You can pull the DC cable manager up and outward to lock it into the maintenance
position.
Chapter 2: MX2020 Hardware Components
Figure 34 on page 60) is located just below the craft
60) is located just below the bottom line card
Figure 34 on page 60).
59