MX2020 3D Universal Edge Router Hardware Guide
Reinstalling the SFBs After Installing the MX2020 Router with a Pallet Jack
104
Close the fan tray access panel, and tighten the captive screws to secure it in place.
7.
Reinstall the remaining components into the router.
8.
Figure 58: Installing Upper Fan Trays
Figure 59: Installing Lower Fan Trays
To reinstall an SFB (see
Figure 60 on page
CAUTION:
Before removing or replacing an SFB, ensure that the ejector
handles are stored horizontally and pressed toward the center of the SFB.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Take each SFB to be installed out of its electrostatic bag, and identify the slot on the
2.
SFB where it will be connected.
Carefully align the sides of the SFB with the guides inside the chassis.
3.
105):
Copyright © 2013, Juniper Networks, Inc.