Installing the MX2020 Air Filter
Copyright © 2013, Juniper Networks, Inc.
Figure 98: Removing the PSM Air Filter from the Chassis
To install the lower air filter—MX2020-FLTR-KIT-S:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Ensure that the air filter is right side up.
2.
Open the fan tray and air filter access door, located at the bottom of the chassis.
3.
Grasp the handle on the air filter and insert into the chassis until it stops, (see
4.
99 on page
226).
Close the access door and tighten the two captive screws to secure.
5.
Lower the cable manager back into position, and rearrange the cables in the cable
6.
manager.
Chapter 13: Replacing MX2020 Router Hardware Components
Figure
225