Reinstalling the Fan Trays After Installing the MX2020 Router with a Pallet Jack
Copyright © 2013, Juniper Networks, Inc.
Figure 57: Reinstalling a DC Power Supply Module
To reinstall the upper or lower fan trays, (see
page
104):
Loosen the two captive screws on each side of the fan tray access panel, and open.
1.
Take each fan tray to be installed out of its electrostatic bag, and identify the slot on
2.
the fan tray where it will be connected.
While grasping the handle, place one hand under the fan tray for support, and align
3.
it into the slot.
Press and hold the latch while guiding the fan tray half way in until it stops.
4.
NOTE:
The fan tray has a safety mechanism so that the fan tray cannot
be removed in one motion.
Press and hold the latch a second time while inserting the fan tray completely into
5.
the router.
Tighten the two captive screws on the fan tray faceplate.
6.
Chapter 7: Installing the MX2020 Router Using a Pallet Jack
Figure 58 on page 104
and
Figure 59 on
103