Jack - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Removing the SFBs Before Installing an MX2020 Router with a Pallet Jack
92
To remove the SFBs (see Figure 50 on page
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Open the ejector handles outward simultaneously to unseat the SFB.
3.
Grasp the ejector handles, and slide the SFB about halfway out of the chassis.
4.
Place one hand underneath the SFB to support it, and slide it completely out of the
5.
chassis. Place it on the antistatic mat.
CAUTION: The weight of the SFB is concentrated in the back end. Be
prepared to accept the full weight—up to 12 lb (5.45 kg)—as you slide the
SFB out of the chassis.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Repeat the procedure for each SFB.
6.
93):
Copyright © 2013, Juniper Networks, Inc.