Figure 86: Do Not Grasp The Connector Edge - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
178
If the MPC is horizontal before you grasp it, place your left hand around the faceplate
and your right hand along the bottom edge.
To hold an MPC horizontally:
Orient the MPC so that the faceplate faces you.
1.
Grasp the top edge with your left hand and the bottom edge with your right hand.
2.
You can rest the faceplate of the MPC against your body as you carry it.
As you carry the MPC, do not bump it against anything. MPC components are fragile.
Never hold or grasp the MPC anywhere except places that this document indicates. In
particular, never grasp the connector edge, especially at the power connector in the
corner where the connector and bottom edges meet.

Figure 86: Do Not Grasp the Connector Edge

Never carry the MPC by the faceplate with only one hand.
Do not rest any edge of an MPC directly against a hard surface (see
Do not stack MPCs.
Figure 87 on page
Copyright © 2013, Juniper Networks, Inc.
179).