Appendix Fmx2020 Cable Connector Pinouts; Rj-45 Connector Pinouts For An Mx Series Cb-Re Management Port; Table 65: Rj-45 Connector Pinout For The Cb-Re Mgmt Port - Juniper MX2020 Hardware Manual

APPENDIX F
MX2020 Cable Connector Pinouts

RJ-45 Connector Pinouts for an MX Series CB-RE MANAGEMENT Port

Related
Documentation
Copyright © 2013, Juniper Networks, Inc.
RJ-45 Connector Pinouts for an MX Series CB-RE MANAGEMENT Port on page 391
RJ-45 Connector Pinouts for MX Series CB-RE AUX and CONSOLE Ports on page 392
The port on the Control Board and Routing Engine (CB-RE) labeled
autosensing 10/100-Mbps Ethernet RJ-45 receptacle that accepts an Ethernet cable for
connecting the Routing Engine to a management LAN (or other device that supports
out-of-band management).

Table 65: RJ-45 Connector Pinout for the CB-RE MGMT Port

Pin Signal
1 TX+
2 TX–
3 RX+
4 Termination network
5 Termination network
6 RX–
7 Termination network
8 Termination network
MX2020 Host Subsystem Description on page 25
Removing an MX2020 CB-RE on page 232
Table 65 on page 391 describes the RJ-45 connector pinout.
is an
MGMT
391