Figure 100: Installing The Middle Card Cage Cable Manager Air Filter - Juniper MX2020 Hardware Manual

Copyright © 2013, Juniper Networks, Inc.

Figure 100: Installing the Middle Card Cage Cable Manager Air Filter

0
Push the air filter in place, close the door, and tighten the two captive screws.
5.
Replace the cables in the middle card cage cable manager, if necessary.
6.
To install the PSM air filter—MX2000-FLTR-PWR-S:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Ensure that the air filter is right side up.
2.
Grasp the PSM air filter and insert into the chassis until it stops, (see
3.
page 228).
Tighten the two captive screws to secure.
4.
NOTE: The AC–powered MX2020 router has the same air filter.
Chapter 13: Replacing MX2020 Router Hardware Components
19
Figure 101 on
227