Figure 155: Three-Phase Wye Ac Power Cord - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation
372

Figure 155: Three-Phase Wye AC Power Cord

NOTE: In North America, AC power cords must not exceed 4.5 m
(approximately 14.75 ft) in length, to comply with National Electrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical
Code (CEC) Section 4-010(3). The cords supplied with the router are in
compliance.
CAUTION: The router is pluggable type A equipment installed in a
restricted-access location. It has a separate protective earthing terminal (size
for UNC 1/4-20 ground lugs) provided on the chassis in addition to the
grounding pin on the power cord. This separate protective earthing terminal
must be permanently connected to earth.
CAUTION: Power cords and cable must not block access to device
components or drape where people could trip on them.
Connecting AC Power to a MX2020 Router with Three-Phase Delta AC Power
Distribution Modules on page 117
Connecting AC Power to a MX2020 Router with Three-Phase Wye AC Power Distribution
Modules on page 122
Replacing an MX2020 Three-Phase Delta AC Power Cord on page 283
Replacing an MX2020 Three-Phase Wye AC Power Cord on page 296
MX2020 Three-Phase Delta AC Power Distribution Module Specifications on page 369
MX2020 Three-Phase Wye AC Power Distribution Module Specifications on page 370
Copyright © 2013, Juniper Networks, Inc.