Removing the MX2020 DC Cable Manager
Copyright © 2013, Juniper Networks, Inc.
Figure 145: Installing the Lower Cable Manager
To remove the DC cable manager (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Grasp the DC cable manager, lift up and pull straight out from the DC PDM on the rear
2.
of the chassis.
Place the DC cable manager into a electrostatic bag and set aside.
3.
Figure 146: Removing the DC Cable Manager
D
Chapter 13: Replacing MX2020 Router Hardware Components
Figure 146 on page
309):
309