Replacing The Mx2020 Craft Interface - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation

Replacing the MX2020 Craft Interface

214
Table 40: Tools and Parts Required for Component
Replacement (continued)
Components
MPC
MIC
Routing Engine and Control Board
(CB-RE)
SFB
Serial cable to Auxiliary or Console
Routing Engine port
PSM air filters
Middle card cage air filter
Air filter (lower)
MX2020 Field-Replaceable Units on page 211
Replacing the MX2020 Craft Interface on page 214
Replacing an MX2020 Fan Tray on page 218
Replacing the MX2020 Air Filters on page 222
Disconnecting the Alarm Relay Wires from the MX2020 Craft Interface on page 215
1.
Removing the MX2020 Craft Interface on page 215
2.
Tool or Part
Phillips (+) screwdrivers, numbers 1 and 2
Blank panels (if component is not reinstalled)
Electrostatic bag or antistatic mat
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic MICs
Flat-blade (–) screwdriver
Electrostatic bag or antistatic mat
Blank panels (if component is not reinstalled)
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic discharge (ESD) grounding wrist strap
Blank panels (if component is not reinstalled)
Phillips (+) screwdrivers, numbers 1 and 2
Electrostatic discharge (ESD) grounding wrist strap
Blank panels (if component is not reinstalled)
Flat-blade (–) screwdriver
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Phillips (+) screwdrivers, numbers 1 and 2
Copyright © 2013, Juniper Networks, Inc.