Avaya Communication Manager Administrator's Manual page 1105

ETHERNET OPTIONS
With each new system or IP board installation, one standard procedure should be to apply
matching speed/duplex settings to each IP board and its corresponding Ethernet switch port.
Then these fields can be used to verify the configured settings. You must set the Enable
Ethernet Pt? field to n before you can make changes to these fields.
Auto
Valid entries
y/n
Duplex
Valid entries
Full
Half
Speed
Valid entries
10Mbps
100Mbps
Usage
Default is y. Enter y for auto-negotiation or n for
manual speed and duplex settings..
Usage
Default is Half. Enter the duplex settings for this IP
board.
Note:
When Speed is set to 100Mbps,
Note:
this field defaults to Full. You do
still have the option of changing the
value to Half.
Usage
Enter the speed of the Ethernet connection.
Note:
When Auto is set to n, the only
Note:
speed option available for the
TN2602AP circuit pack is
100Mbps. This is the default and
cannot be changed.
IP Interfaces
Issue 1 June 2005 1105