Avaya Communication Manager Administrator's Manual page 1596

Screen Reference
Busy Tone Disconnect
The field appears when Enable Busy Tone Disconnect for Analog loop-start Trunks is y on
the System Parameters Country-Options screen.
Valid entries
y/n
Cama Outgoing Dial Guard (msec)
This field appears when Group Type is cama (the trunk group type used for emergency 911
service).
Valid entries
25 to 6375 in
increments of 25
Cama Wink Start Time (msec)
This field appears when Group Type is cama.
Valid entries
20 to 5100 in
increments of 20
Disconnect Signal Error (sec)
This field appears for ground-start trunk groups.
Valid entries
1 to 255 in
increments of 1
1596 Administrator Guide for Avaya Communication Manager
Usage
Enter y to allow Communication Manager to recognize a
busy tone signal as a disconnect on this trunk group.
Usage
Enter the minimum interval between the seizure
acknowledgment on the receiving server or switch and
the outpulsing of digits by this server.
Usage
Specifies the duration (the wait-for-wink-to-end time) for
a wink-start CAMA trunk. The wink must begin before
the Outgoing Seizure Response timer expires.
Usage
Enter the maximum interval that Communication
Manager will wait to receive a disconnect signal from
the far-end after the local party (a telephone or tie trunk)
goes on-hook. If the timer expires, Communication
Manager assumes a disconnect failure and takes
appropriate action, such as creating an error message.