Avaya Communication Manager Administrator's Manual page 1607

Frequency
This field identifies the PPM pulse frequency(ies) sent by the public network. It appears if the
Direction field is outgoing or two-way and PPM is y. Circuit packs can detect up to three
different frequencies, (12kHz, 16kHz, and 50Hz), plus two frequency combinations, (50Hz/
12kHz and 50Hz/16kHz). This field controls TN465B, TN2138, and TN2184 circuit packs.
Valid entries
12k
16k
50
50/12k
50/16k
Make (msec)
Valid entries
Enter the duration of the make interval (the pause between pulses) while the
system is outpulsing digits using dial pulse signaling. The field cannot be
blank.
20 to 80 in
increments of 5
10 to 40 in
increments of 5
Usage
The TN465B (or later) and TN2184 can only detect 12k
and 16kHz PPM. Therefore, if 12k is administered, the
circuit pack will be set to detect 12kHz.
The TN465B (or later) and TN2184 can only detect 12k
and 16kHz PPM. Therefore, if 16k is administered, the
circuit pack will be set to detect 16kHz.
The TN465B (or later) and TN2184 can only detect 12k
and 16kHz PPM. Therefore, if 50 is administered, the
circuit pack will be set to detect 16kHz.
The TN465B (or later) and TN2184 can only detect 12k
and 16kHz PPM. Therefore, if 50/12k is administered,
the circuit pack will be set to detect 12kHz.
The TN465B (or later) and TN2184 can only detect 12k
and 16kHz PPM. Therefore, if 50/16k is administered,
the circuit pack will be set to detect 16kHz.
Usage
If the PPS field is 10, the sum of the Make (msec) and
Break (msec) fields must equal 100.
If the PPS field is 20, the sum of the Make (msec) and
Break (msec) fields must equal 50.
Trunk Group
Issue 1 June 2005 1607