Avaya Communication Manager Administrator's Manual page 1601

Outgoing Disconnect Send (msec)
This field is administrable only if the Trunk Type field is dis and the trunk group Direction field
is two-way or outgoing. Only TN2140 ports receive this timer.
Valid entries
100 to 9900 in
increments of
100
Outgoing End of Dial (sec)
This field controls firmware answer supervision timers on circuit packs that have them. It
appears when the Direction field is outgoing or two-way and the Receive Answer
Supervision field is n. If the Receive Answer Supervision field is y, this field does not appear
and the firmware timer on the appropriate circuit pack is automatically disabled.
Note:
The Answer Supervision Timeout field on the Trunk Group screen provides
Note:
timed answer supervision for circuit packs without administrable timers. Since
trunk groups may contain ports on more than one circuit pack, it's possible you
may need to use both timers with the same trunk group. If so, set the Outgoing
End of Dial field and the Answer Supervision Timeout field to the same value.
Valid entries
1 to 254 in
increments of 1
During a cut-through operation, timing begins after Communication Manager sends each
outgoing digit and ceases when answer supervision is received. If the timer expires,
Communication Manager acts as if it has received answer supervision. On senderized
operation, the timer begins after the switch sends the last digit collected. The timer ceases
when answer supervision is received. If the timer expires, Communication Manager acts as if it
has received answer supervision.
Usage
Enter the duration of the forward release signal your
server running Communication Manager sends at the
end of outgoing calls.
Usage
Enter the maximum time, in seconds, that
Communication Manager will wait to receive answer
supervision for outgoing calls on the ports controlled by
firmware timers. For Brazil pulsed E&M signaling, use
40.
Trunk Group
Issue 1 June 2005 1601