Avaya Communication Manager Administrator's Manual page 1571

Valid entries Usage
cont E&M trunks in Italy, Brazil, and Hungary can use either continuous
(continuous) or discontinuous signaling. Each entry specifies a set of signals
and available timers used in the process of setting up and
dis
releasing connections. The type of signaling you select on
(discontinuous)
Communication Manager must match the signaling type
administered on the far-end media server or switch. Use these
values only when all trunk group members are assigned to ports on
a TN464F, TN2464, or TN2140 circuit pack. Entering one of these
values causes the Send Release Ack, Receive Release Ack, and
Send Answer Supervision fields to appear. See
out)
Use the following entries for tie trunks in Main-Satellite/Tributary networks. Each entry
defines a function of the trunk group in the network. Use these values only when all
trunk group members are assigned to a TN497 circuit pack.
tgu Enter tgu at the main server running Communication Manager to
(for outgoing administer a tie trunk group connected to a satellite server. (This
trunks) same group should be administered as tge at the satellite.)
tge Enter tge at a satellite server to administer a tie trunk group
(for incoming connected to the main server running Communication Manager.
trunks) (This same group should be administered as tgu at the main
server.)
tgi Enter tgi at to administer a two-way tie trunk group between 2
(for internal satellites or between the main server and a satellite. (This trunk
trunks) group should be administered as tgi on both servers.)
DIOD trunks support pulsed and continuous E&M signaling in Brazil and discontinuous
E&M signaling in Hungary. Use the following entries for DIOD trunks. Use these values
only when all trunk group members are assigned to a TN464F (or later version) or
TN2464 circuit pack.
cont Enter cont for continuous E&M signaling.
pulsed Enter pulsed for pulsed E&M signaling.
discont Leave blank forR2 signaling.
Hungary uses discontinuous E&M signaling when this field is dis.
Brazil E&M trunks use continuous and pulsed E&M.
on page 1574 for more information.
Trunk Group
Trunk Type (in/
Issue 1 June 2005 1571