Avaya Communication Manager Administrator's Manual page 1537

Analog Loss Group
This field determines which administered 2-party row in the loss plan applies to this trunk group
if the call is carried over an analog signaling port in the trunk group.
Valid entries
1 to 17
Answer Supervision Timeout
If the Receive Answer Supervision field is n, use this field to set the answer supervision timer
for outgoing and two-way trunks. During a cut-through operation, timing begins after each
outgoing digit is sent by Communication Manager and timing ceases after the far-end sends
answer supervision. If the timer expires, Communication Manager acts as if it had received
answer supervision. On senderized operation, the timer begins after the last digit collected is
sent.
Valid entries
0 to 250
Note:
This field's setting does not override answer supervision sent from the network or
Note:
from DS1 port circuit timers. To control answer supervision sent by DS1
firmware, set the Outgoing End of Dial (sec) field on the Administrable Timers
page of the Trunk Group screen.
Auth Code
This field affects the level of security for tandemed outgoing calls at your server running
Communication Manager. This field appears if the Direction field is incoming or two-way, and it
can only be y if the Authorization Codes field is y on the
Customer-Options
Valid entries
y/n
Usage
Shows the index into the loss plan and tone plan.
Usage
Enter the number of seconds you want Communication
Manager to wait before it acts as though answer
supervision has been received from the far-end. Set this
field to 0 if Receive Answer Supervision is y.
screen.
Usage
Enter y to require callers to enter an authorization code
in order to tandem a call through an AAR or ARS route
pattern. The code will be required even if the facility
restriction level of the incoming trunk group is normally
sufficient to send the call out over the route pattern.
System-Parameters
Issue 1 June 2005
Trunk Group
1537