Avaya PARTNER ACS Installation And Use Manual page 347

CAUTION:
Do not force the module. Use the carrier shelf as a reference and do not tilt, slant or
rotate the module. If the module does not insert easily, remove it, clear any obstruction,
and reinsert it.
9. Connect the line and extension cords one at a time, making sure to place the correct cords into
their corresponding jacks on the new module. (See
page 2-16.)
10. Reconnect the power cord.
CAUTION:
The power cord should hang straight down from the connector, flush against the plastic
case. Do not install the power cord at an angle to the case or with a loop in it.
11. Move the carrier's On/Off switch to the "On" position ("–").
12. Check that all green lights on the fronts of the modules are lit:
If a single light is out, power down the control unit, reseat the module, and power up the
I
control unit.
If multiple lights are out, power down the control unit, reseat the leftmost module that has a
I
light out, and power up the control unit.
If the lights are still out, call for support as instructed on the inside front cover of this guide.
I
13. Make sure all modules are seated properly.
14. If you have a system of Release 3.0 or earlier:
a. Replace the cover by grasping it by its upper edges and holding it squarely over the control
unit (see Figure
place.
Figure 10-14. Replacing the Cover
b. Tighten the screw on the lower front of the cover.
10-14). Place the cover over the modules and make sure it fits firmly in
Upgrading the System
"Connecting Lines and Extensions" on
Replacing Modules
10-15