Avaya PARTNER ACS Installation And Use Manual page 67

You use the following special buttons while programming:
N and P
I
procedures. You can use these buttons to select a procedure.
(If a procedure instructs you to press
after the other enables you to repeat the current programming procedure.)
n and p
I
parameter is typically an outside line, a pool, an extension, or a telephone list entry.
D d
and
I
work only for fixed data, such as a line or extension number. They do not work for variable data
such as date, time, password, telephone numbers, or doorphone assignments.
r returns the current setting to the factory setting. When you are programming Line
I
Assignment (#301), pressing
programming Pool Extension Assignment (#314), pressing
extension.
e ends an entry of variable length, such as a telephone number in an Allowed Phone
I
Number List.
s
starts the System Programming process.
I
c
starts the Centralized Telephone Programming process (to customize individual
I
telephones centrally from extension 10 or 11).
f
, when followed by
I
w
enters a "wildcard" (a character that matches any digit dialed) in telephone numbers in
I
Allowed Phone Number Lists (#407), Disallowed Phone Number Lists (#404), and the
Forced Account Code List (#409).
cycle forward and backward through the programming
N
cycle forward and backward through a procedure's parameters. A
cycle forward and backward through the valid entries. These buttons
r
removes lines from an extension; when you are
00
, enters or exits programming mode.
Initial System Programming
P
+ , pressing these buttons one
r
removes pools from an
Using System Programming
3-3