Programming Connections For The 1600 Dsl Module; Initial Configuration Of The 1600 Dsl Module - Avaya PARTNER ACS Installation And Use Manual

Programming Connections for the 1600 DSL Module

The programming of the 1600 DSL module is
separate from the programming of the PARTNER
ACS. You can program the 1600 DSL module either
locally or remotely.
To locally program the module, connect a cable from
a PC's serial port to the Console port on the module.
For Release 4.0 or later, you can set up the module
for remote programming by following these steps
(see Figure 2-22):
1. Connect a cable from an extension port on the
system to the Line jack on an external modem.
The modem should have the following
parameters:
14.4 kbps or greater
I
Auto-Answer is enabled
I
DTR override is enabled
I
Echo commands are Suppressed
I
Result and Error codes are Suppressed
I
2. Connect a cable from the serial port on the
modem to a null modem.
3. Connect a cable from the null modem to the
Console port on the 1600 DSL module.

Initial Configuration of the 1600 DSL Module

Beginning with Release 5.0 or later, remote administration of the 1600 DSL module is available
through the PARTNER ACS Remote Administration and Diagnostics PC software. You must have
the following:
Release 5.0 or later software on the 1600 DSL module
I
Release 5.0 or later software version of PARTNER ACS
I
Release 5.0 or later PARTNER ACS Remote Administration and Diagnostics PC software
I
For more information, see the PARTNER ACS Remote Administration and Diagnostics R5.0
Getting Started guide.
PARTNER ACS
Tip/Ring
Extension Port
1600 DSL Module
Console Port
Figure 2-22. Remote Programming
Setup
The 1600 DSL Module
Installation
External Modem
Null Modem
2-19