Avaya PARTNER ACS Installation And Use Manual page 337

7. Follow the procedures below:
a. If you are upgrading from Release 1.0 to Release 2.0, power down and remove the PC
upgrade card.
b. If you are upgrading to Release 3.0 or later, do not remove the PC card. The card
automatically converts to a backup/restore and remote access card. If you removed
other PC cards, PVM or ASA/DXD, for example, power down the system and reinstall
the PC cards after the upgrade is complete.
8. If you have a 2-slot carrier or a stand-alone configuration, you are finished with this procedure.
If you have a 5-slot carrier, continue with Step 9.
9. Make sure all modules are seated properly.
10. If you have a system of Release 3.0 or earlier:
a. Replace the cover by grasping it by its upper edges and holding it squarely over the control
unit (see Figure
place.
Figure 10-3. Replacing the Cover
b. Tighten the screw on the lower front of the cover.
10-3). Place the cover over the modules and make sure it fits firmly in
Upgrading the System
Using a PC Card
10-5