Contact Closure Adjunct; Connecting The Contact Closure Adjunct - Avaya PARTNER ACS Installation And Use Manual

5. Select another procedure, or exit programming mode.

Contact Closure Adjunct

The Contact Closure Adjunct plugs into a jack on the processor module and has two Contact
Closures to control devices such as an electronic door lock (as shown in
The device being controlled must be wired to the Adjunct by an electrician in accordance with local
electrical codes.
Program the following features to enable the use of the Contact Closure Adjunct:
Contact Closure Group
I
Contact Closure Operation Type
I
Figure 9-5. Contact Closure Adjunct

Connecting the Contact Closure Adjunct

Follow these steps to connect the Contact Closure Adjunct (see
1. Insert the modular plug into the Contact Closure jack, the first jack on the PARTNER ACS
processor module.
2. Route the cord through the processor module's wire manager.
3. Connect the other end of the cord to the jack in the Contact Closure Adjunct.
4. Have a qualified electrician wire the Contact Closure device or devices (such as an electronic
lock or alert) to the wiring receptacles in the other end of the Contact Closure Adjunct. See the
information shipped with the Contact Closure Adjunct for wiring instructions.
Contact
Closure
Adjunct
Ext X
PARTNER
ACS
Ext Y
Contact
Closure
Door with
1
Electronic
Lock
Doorphone
Doorphone
Alert
Extension
Figure
Using Auxiliary Equipment
Figure 9-5) or an alert.
9-6):

Contact Closure Adjunct

9-9