Examples - Avaya PARTNER ACS Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use

Examples

Pause: To call an answering machine at 555-0529, wait 4.5 seconds; then dial
I
retrieve messages, enter
Recall/Centrex Feature Button: The following entry shows how to program an Auto Dial
I
button with a Centrex feature you use while on a call, for which the feature access code is *32 .
This example includes a Recall signal to send a switchhook flash to the Centrex system when
you are already on a call. (You can store a Recall signal by pressing
first character stored.) It also includes a 1.5-second pause (which you insert by pressing
to allow time to get a new Centrex dial tone:
Stop: Your local bank-by-phone service requires that you enter a password before the account
I
number. To program a Personal Speed Dial number or an Auto Dial button to call the bank at
555-7898, include a stop for manually entering the password, and continue with the account
number (679 88), enter
Touch-Tone Enable: Your system is connected to rotary lines but you want to call an
I
answering machine at 555-3454 to retrieve messages. Since the machine requires touch
tones, enter 5553454&
touch tones.
On/Off Centrex Feature Button: To include both the activation and deactivation codes for a
I
Centrex feature on the same button, press
For instance, if the code to activate a Centrex feature is
feature is *31
The first time you press the Auto Dial button, only the number before the stop is dialed (to
activate the feature). When you press the button again, the rest of the stored number is dialed
(to deactivate the feature).
Number Outside a PBX or Centrex System: To store a number that dials out of a PBX or
I
Centrex system, include a dial-out code in the Speed Dial number. This entry, to dial the
number 201 555-4321, includes a dial-out code, a 1.5-second pause, and a toll call prefix of 1
for direct dialing (which may not be required for your dialing area):
4321
.
Examples
B-2
5550529hhh321
5557898!67988
. All digits pressed during the rest of the call are sent as
, store *30!*31
Sh*32
.
.
!
to include a stop between the two codes.
*30
and the code to deactivate the
on the Auto Dial button.
321
to
.
S
, but only if it is the
h
9h1201555
)