Avaya PARTNER ACS Installation And Use Manual page 327

Programming for Automatic VMS Cover
To change the Automatic VMS Cover setting for an extension:
f00ss#310
1. Press
2. Enter the number of the extension to be covered by the voice messaging system.
3. To assign or unassign Automatic VMS Cover, press
appears.
1 = Assigned
I
2 = Not Assigned (the factory setting) ✔
I
4. To program another extension, press
on the display. Then repeat Step 3.
5. Select another procedure, or exit programming mode.
VMS Cover Rings (321#)
Use this feature to define the number of times a call rings before it is sent to a user's voice
mailbox. Use VMS Cover Rings (#117) for Release 2.0 or earlier systems to program the number
of rings for all extensions programmed for VMS Cover. Use VMS Cover Rings (#321) for Release
3.0 and later systems to program the number of rings on a per-extension basis.
Considerations
VMS Cover Rings also applies to lines that have been designated an owner with Line
I
Coverage Extension (#208).
If an extension has VMS Cover (F15) or Automatic VMS Cover (#310) active, unanswered
I
calls to that extension are routed to the voice messaging system after the specified number of
VMS Cover Rings.
Programming For VMS Cover Rings (#117)
To change the number of times calls ring before being sent to the voice messaging system:
1. Press f00ss#117
2. Enter a setting (1—9; 3 is the factory setting). For example, to set VMS Cover Rings to 4,
D
press or
VMS Cover Rings
4 Rings
3. Select another procedure, or exit programming mode.
n
d
until a display similar to the following appears:
Using Auxiliary Equipment
at extension 10 or 11.
D
until the appropriate value
p
or until the extension number appears
at extension 10 or 11.
Voice Messaging Systems
9-43