Programming - Avaya PARTNER ACS Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
After you finish Line Assignment, use Line Ringing to identify when each outside line
I
assigned to an extension should start ringing. If you add a line to the system, its factory setting
is Immediate Ring.
Use Automatic Line Selection to determine the order in which the system selects a line for
I
an extension when the user at that extension lifts the handset or turns on the speaker to make
a call. If you add a line to the system, it becomes the last line in the selection sequence.

Programming

To assign lines to a specific extension:
1. Press f00ss#301
2. Enter the extension number to be programmed. For example, to program extension 15, press
15
. The red light next to each button that has a line assigned is on steady; the red light next
to each button that has a pool assigned flashes.
3. To remove all existing line assignments, press
4. Enter the line number to be assigned. For example, to select line 1, press
5. Do one of the following:
If you want to assign the line to the first available button with lights, press
I
display reads:
Line Assignment 15 L01
1 Assigned
1 Assigned is the factory setting.
If you want to remove a line assignment, press
I
appears:
Line Assignment 15 L01
2 Not Assigned
If you want to assign the line to a specific button, press
I
appears:
Line Assignment 15 L01
3 Select a Button
Then press a button with lights to assign the line to that button. If you use option 3 after a
line already has been assigned, the line moves from the old button to the new button you
select.
6. Do one of the following:
To program another line for this extension, press
I
appears on the display. Then repeat Step 5.
To program another extension, press
I
7. Select another procedure, or exit programming mode.
Line Assignment (#301)
4-42
at extension 10 or 11.
r
before selecting a line.
✔
D
n
N P
01 .
D
until a display like the following
3
. A display like the following
p
or until the line number
and begin at Step 2.
until the