System Reset-Programming Saved (#728); Considerations; Programming - Avaya PARTNER ACS Installation And Use Manual

System Reset–Programming Saved (#728)
Use this feature to reset the system while retaining the currently programmed settings. Reset the
system only when advised to do so by technical support personnel.

Considerations

Resetting the system disconnects all active calls.
I
This procedure is skipped in the sequence of programming procedures when cycling. To use
I
this procedure, enter the code directly.
The system reset begins immediately and takes only a few seconds.
I
You cannot interrupt the reset process or use any telephones in the system during the reset
I
process.
Most of the system and telephone programming settings that were in effect before the power
I
failure or down period are retained; they do not revert to the default settings.
Automatic System Answer Button (#111), Direct Extension Dial Button (#113), Night
I
Service Button (#503), and Station Lock return to the status (on or off) that they were in
immediately prior to the system reset.
The VMS Cover button and Privacy button return to the status (on or off) determined by the
I
programmed setting of Automatic VMS Cover (#310) and Automatic Extension Privacy
(#304), respectively. For example, if Automatic Extension Privacy is Assigned and the
Privacy button is on when a system reset occurs, the Privacy button will be on again after the
system reset. However, if Automatic Extension Privacy is Not Assigned and the Privacy
button is on when a system reset occurs, the Privacy button will be off after the system reset.
A successful use of Restore Programming (#125) causes a System Reset–Programming
I
Saved to occur.
The information stored in the Save Number Redial (F04) and the Last Number Redial (F05)
I
buffers is lost when a System Reset–Programming Saved occurs.
You can use System Reset–Programming Saved to restore the configuration in the 1600
I
DSL module.

Programming

To reset the system, press
A display similar to the following appears:
Reset - Save All
When the reset is completed, the system is no longer in Programming Mode and the date and time
appear on the display.
f00ss#728
Programming System Options
System Reset–Programming Saved (#728)
at extension 10 or 11.
4-55