Line Access Mode (#313); Considerations; Programming - Avaya PARTNER ACS Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use

Line Access Mode (#313)

Use this feature to identify individual extensions that are to operate as key extensions even though
the system is configured for Hybrid mode. If an extension's Line Access Mode is changed to Key,
individual lines can be assigned to specific buttons on that extension's telephone regardless of
whether they are part of a pool.
This feature applies only to systems of Release 2.0 or later that are configured for Hybrid mode.

Considerations

Extension 10 operates as a key extension regardless of how the system is configured. The
I
Line Access Mode for extension 10 cannot be changed.
Users at extensions programmed as key extensions cannot access pools either by pressing
I
pool buttons or by dialing pool access codes.
When an extension is changed from Pooled to Key, any previously assigned pool buttons are
I
removed from the extension and Pool Access Restriction (#315) is set to No Access.
Additionally, the extension is programmed with factory settings for Line Assignment (#301),
Line Access Restriction (#302), Automatic Line Selection, and Line Ringing.
When an extension is changed from Key to Pooled, any previously assigned line buttons are
I
removed from the extension and Pool Access Restriction (#315) is set to No Restriction.
Additionally, the extension is programmed with factory settings for Pool Line Assignment
(#314), Pool Extension Assignment (#314), Automatic Line Selection, and Line Ringing.

Programming

To change the Line Access Mode setting for a specific extension:
f00ss#313
1. Press
2. Enter the desired extension number. For example, to program extension 18, press
3. Press D
1 = Pooled–(When this is chosen, the factory setting is all extensions except 10.)
I
2 = Key–(When this is chosen, the factory setting is extension 10 only.)
I
4. To program another extension, press
on the display. Then repeat Step 3.
5. Repeat Steps 3 and 4 for all extensions that you want to change.
6. Select another procedure, or exit programming mode.

Line Access Mode (#313)

4-40
until the appropriate value appears:
n
.
p
or until the extension number appears
18
.