Call Coverage Rings (#116 Or #320) - Avaya PARTNER ACS Installation And Use Manual
Advanced communications system
Hide thumbs
Also See for PARTNER ACS:
- System planner manual (54 pages) ,
- Installation and use manual (468 pages)
Table of Contents
Advertisement
3. Choose the backup file you want to use for the restore:
1 MAN.mmddyy , where "mmddyy" represents the date of the manual backup on this card
I
2 AUTO.mmddyy , where "mmddyy" represents the date of the automatic backup on this
I
card.
I
I
e
4. Press
to start the restore.
If the system detects an error before beginning the restore, the bottom line of the display
shows one of the following messages (See
about these messages):
Insert Card or Insert Valid Card
I
Bad File or Bad File-Try Again
I
Incompat Version or Incompatible Versions
I
I
Empty File
If the system does not detect an error, the restore begins. One of the following occurs:
When the restore has completed successfully, the bottom line of the display shows
I
Restore Complete for two seconds. Then the system resets itself, which means that all
calls in progress are disconnected. You are no longer in System Programming mode.
If the restore is not successful, the display shows Restore Failed or Restore
I
Failed-Try Again for two seconds. All calls in progress are disconnected and all of the
system and telephone programming settings revert to the factory settings. You are no
longer in System Programming mode. Try the restore again.
Call Coverage Rings (#116 or #320)
Use this feature to define the number of times intercom, transferred, and outside calls on lines
assigned ownership ring at an extension before they are sent to the covering extension. In Release
2.0 of the system, when you program Call Coverage Rings (#116), it applies to all system
extensions programmed for Call Coverage. In systems of Release 3.0 or later, you can program
Call Coverage Rings (#320) on an individual extension basis.
If the date of the file (AUTO. mmddyy or MAN. mmddyy) indicates that this is
not the file you intended to use, see the instructions packaged with the PC
Upgrade card for how to install the Backup/Restore PC Card.
If the Backup/Restore PC Card is fresh from the factory, and no backups have
been recorded on it yet, the filenames are MAN . ****** and AUTO . ****** ,
respectively. You cannot use these files for a restore; they generate the error
message Empty File after you press
Programming System Options
e
in Step 4.
Chapter 11, "Troubleshooting"
Call Coverage Rings (#116 or #320)
for more information
4-7
Advertisement
Chapters
Table of Contents
