Restore Programming (#125) - Avaya PARTNER ACS Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
If the backup failed, you see one of the following error messages (see
"Troubleshooting"
I
Backup Failed:Check Card
I
Backup Failed:SystemBusy
4. Exit programming mode.
If you exit the procedure before the backup finishes, you do not interrupt the backup,
but you do not see feedback messages on the display.

Restore Programming (#125)

Use this feature to reinstate your system and telephone programming (except the System Day,
System Date, and System Time) to the settings saved on a PC Card at the last system backup
(manual or automatic). You should restore the system settings if your system settings become
corrupted, if you make changes and decide you would rather use the former settings, or if you
replace your processor module and want to retain the system settings you had on the previous
processor module. A successful restore takes about five seconds.
When a restore completes successfully, the Restore Complete message appears for two
seconds at idle extensions 10 and 11. Then a System Reset–Programming Saved
(#728) occurs, disconnecting any calls in progress. You should warn users before
beginning a restore, or do the restore during nonbusiness hours.
Considerations
Make sure that you have saved the most recent system settings before you begin the Restore
I
procedure.
If the restore is not successful, the display shows Restore Failed or Restore Failed-
I
Try Again for two seconds. All calls in progress are disconnected, and all of the system and
telephone programming settings revert to the factory settings.
The configuration of the 1600 DSL module is not saved on the PC card; it is retained in the
I
flash memory of the 1600 DSL module. To restore this configuration, you must perform a cold-
start by using Restore Programming or System Reset–Programming Saved (#728).
Using Restore
To initiate a restore:
1. If you have a Backup/Restore PC Card installed, skip to Step 2. If you do not have a PC Card
installed, see "Using a PC Card" on page 10-2
Instructions that came with your PC Card.
f00ss#125
2. Press
The top line of the display shows Sys Set Restore or System Settings Restore .
Backup and Restore
4-6
for explanations and corrective actions):
or refer to the PARTNER PC Card Installation
at extension 10 or 11.
Chapter 11,