Using System Programming; Programming Overlays - Avaya PARTNER ACS Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
Endeavor telephones are supported in PARTNER ACS Release 5.0 or later when an
Endeavor 362EC module is installed in the carrier. The Endeavor telephones are
programmed the same as PARTNER-34D, -18D, -18 and -6 telephones and have the
same button layouts.
The PARTNER ACS Release 3.0 or later includes a PARTNER Remote Access PC Card,
which allows you to program the system remotely or locally from a PC and perform
backup and restore functions. The PARTNER Remote Access PC Card is a PCMCIA
card that can also be used to upgrade the system to the most current release. You must
have additional PARTNER Remote PC Software to program the system remotely. See
your Avaya representative or authorized dealer for more information.
Programming procedures use line and extension numbers. The line number represents the line
jack on a module to which the outside line is connected. The extension number represents the
extension jack on a module to which the system telephone or tip/ring device is connected.
If you are installing a voice messaging system with the PARTNER ACS, you must assign
the voicemail ports to Hunt Group 7 to avoid having the voicemail ports answering all calls
immediately. See

Using System Programming

System Programming changes settings for the system as a whole, or for individual lines, pools, or
extensions. You can also use System Programming to set up dialing restrictions, define groups, or
set up auxiliary equipment. Refer to the filled-out System Planner when you are changing system
settings, and be sure that any changes in programming are recorded there.

Programming Overlays

To do System Programming, you place a Programming Overlay over the dialpad of the system
display telephone at extension 10 or 11. (Overlays are provided with the system documentation.)
Figure 3-1 on page 3-4
18D telephones.
During System Programming, the normal functions of several buttons on the display telephone at
extension 10 or 11 change. For example, the left
i
right button becomes

Using System Programming

3-2
"To Program a Voice Messaging System" on page
shows the Programming Overlays for the PARTNER-34D and PARTNER-
c
. The Programming Overlay identifies these buttons.
i
button becomes
9-41.
s
and the