Replacing Modules; Replacing Modules In A Stand-Alone Or 2-Slot Carrier Configuration - Avaya PARTNER ACS Installation And Use Manual

6. Push slowly but firmly in the center of the module until the module locks into place and is
attached to the rear of the carrier. Do not force the module. If the module does not insert
easily, remove it, clear any obstruction, and reinsert it.
7. Connect line and/or extension jack cords to the new module (see
Extensions" on page
8. Reconnect the power cord to the wall outlet.
CAUTION:
The power cord should hang straight down from the connector, flush against the plastic
case. Do not install the power cord at an angle to the case or with a loop in it.
9. Move the On/Off switch to the "On" position ("–").
10. Check that all green lights on the fronts of the modules are lit:
If a single light is out, power down the control unit, reseat the module, and power up the
I
control unit.
If multiple lights are out, power down the control unit, reseat the leftmost module that has a
I
light out, and power up the control unit.
If the lights are still out, call for support as instructed on the inside front cover of this guide.
I
11. Make sure all modules are seated properly. (For Release 3.0 and earlier systems, the cover
will not fit if the modules are not seated properly.) If you have a system of Release 4.0 or later,
you are finished with this procedure. If you have a system of Release 3.0 or earlier, continue
with Step 12.
12. To replace the cover, grasp it by its upper edges and hold it squarely over the control unit.
Place the cover over the modules and make sure it fits firmly in place.
13. Tighten the screw on the lower front of the cover.

Replacing Modules

Replacing system modules is similar to how you originally installed modules into the control unit.
The procedure varies slightly between the stand-alone/2-slot carrier configuration and the 5-slot
carrier configuration.
Replacing Modules in a Stand-Alone or 2-Slot
Carrier Configuration
CAUTION:
Before starting, verify that you have batteries installed in the processor module by viewing
the display of the telephone at extension 10.
2-16).
Upgrading the System
"Connecting Lines and

Replacing Modules

10-9