Display Tunnel; Clear Security 12-Restrict; Clear Security 12-Restrict Counters - 3Com WX4400 Command Reference Manual

114 C 5: VLAN C
HAPTER

display tunnel

WX4400# display tunnel
VLAN
--------------- --------------- --------------- ------- ----- ----- -----
vlan-eng
OMMANDS
Table 23 Output for display security 12-restrict
Field
Hits
See Also
clear security 12-restrict on page 103
clear security 12-restrict counters on page 104
set security l2-restrict on page 118
Shows the tunnels from the wireless LAN switch where you type the
command.
Syntax — display tunnel
Defaults — None.
Access — Enabled
History —Introduced in MSS Version 3.0.
Examples — To display all tunnels from a WX switch to other WX
switches in the Mobility Domain, type the following command.
Local Address Remote Address
192.168.14.2 192.168.14.4
Table 24 describes the fields in the display.
Table 24 Output for display tunnel
Field
VLAN
Local Address
Description
Number of packets whose source MAC address was a
client in this VLAN, and whose destination MAC address
was one of those listed under Permit MAC.
State
DORMANT
Description
VLAN name.
IP address of the local end of the tunnel. This is the system
IP address of the wireless access switch where you enter
the command.
Port LVID RVID
1024 4096 130