Mac Acl - NETGEAR GS752TP Software Administration Manual

ACL Based on
Destination IPv6 L4
Port
Source IPv6 L4 Port
4. In the Binding Configuration area, the Inbound only packet filtering direction for an ACL is
selected in the Direction field.
5. In the Port Selection Table area, specify the list of all available valid interfaces for ACL
mapping.
All non-routing physical interfaces and interfaces participating in the LAG are listed.
6. To add a rule to the ACL, select the check box next to the ACL, then click ADD.
7. Click APPLY to update the switch with the new settings.
Configuration changes take effect immediately.

MAC ACL

A MAC ACL consists of a set of rules that are matched sequentially against a packet. When a
packet meets the match criteria of a rule, the specified rule action (permit or deny) is taken
and the additional rules are not checked for a match.
The steps for defining a MAC ACL and applying it to the switch are described in the following
sections:
1. Use the MAC ACL
2. Use the MAC Rules
3. Use the MAC Binding Configuration
4. Optionally, use the
To configure a MAC ACL:

1. Select Security
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Fields
• Destination L4 port (protocol). Specify the destination IPv6 L4 port protocol.
• Destination L4 port (value). Specify the destination IPv6 L4 port value.
• Source L4 port (protocol). Specify the source IPv6 L4 port protocol.
• Source L4 port (value). Specify the source IPv6 L4 port value.
screen to create the ACL ID.
screen to create rules for the ACL.
screen to assign the ACL by its ID number to a port.
MAC Binding Table
ACL > Basic > MAC ACL.

Managing Device Security
screen to view the configurations.
191