Show Network - NETGEAR ProSAFE M7100-24X Reference Manual

ProSAFE M7100 Managed Switches

show network

Use this command to display configuration settings associated with the switch's network
interface. The network interface is the logical interface used for in-band connectivity with the
switch via any of the switch's front panel ports. The configuration parameters associated with the
switch's network interface do not affect the configuration of the front panel ports through which
traffic is switched or routed. The network interface is always considered to be up, whether any
member ports are up; therefore, the show network command will always show "Interface Status"
as "Up".
Format
show network
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Status The network interface status; it is always considered to be "up".
IP Address The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6 Whether enabled or disabled.
Administrative
Mode
IPv6 The IPv6 address and length.
Address/Length
IPv6 Default The IPv6 default router address.
Router
Burned In MAC The burned in MAC address used for in-band connectivity.
Address
Locally If desired, a locally administered MAC address can be configured for in-band connectivity. To
Administered take effect, 'MAC Address Type' must be set to 'Locally Administered'. Enter the address as
MAC Address twelve hexadecimal digits (6 bytes) with a colon between each byte. Bit 1 of byte 0 must be
set to a 1 and bit 0 to a 0, i.e. byte 0 should have the following mask 'xxxx xx10'. The MAC
address used by this bridge when it must be referred to in a unique fashion. It is
recommended that this be the numerically smallest MAC address of all ports that belong to
this bridge. However it is only required to be unique. When concatenated with
dot1dStpPriority a unique BridgeIdentifier is formed which is used in the Spanning Tree
Protocol.
MAC Address The MAC address which should be used for in-band connectivity. The choices are the burned
Type in or the Locally Administered address. The factory default is to use the burned in MAC
address.
Management Commands
498