Show Router Ospf Interface Info - NETGEAR ProSafe GSM7312 User Manual
Layer 3 managed switch software
Hide thumbs
Also See for ProSafe GSM7312:
- Hardware installation manual (22 pages) ,
- Datasheet (3 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
show router ospf interface info
This command displays the information for the IFO object or virtual interface tables.
Format
IP Address
Subnet Mask
OSPF Admin Mode
OSPF Area ID
Router Priority
Retransmit Interval
Hello Interval
Dead Interval
LSA Ack Interval
Iftransit Delay Interval
Authentication Type
The information below will only be displayed if OSPF is enabled.
OSPF Interface Type
State
Designated Router
Backup Designated Router
Number of Link Events
Metric Cost
8-16
show router ospf interface info <slot.port>
Represents the IP address for the specified interface. This is a configured value.
A mask of the network and host portion of the IP address for the OSPF interface.
This value was configured into the unit. This is a configured value.
States whether OSPF is enabled or disabled on a router interface. This is a
configured value.
Represents the OSPF Area Id for the specified interface. This is a configured
value.
A number representing the OSPF Priority for the specified interface. This is a
configured value.
A number representing the OSPF Retransmit Interval for the specified interface.
This is a configured value.
A number representing the OSPF Hello Interval for the specified interface. This
is a configured value.
A number representing the OSPF Dead Interval for the specified interface. This
is a configured value.
A number representing the OSPF LSA Acknowledgement Interval for the
specified interface.
A number representing the OSPF Transit Delay for the specified interface. This
is a configured value.
The OSPF Authentication Type for the specified interface are: none and simple.
This is a configured value.
Broadcast LANs, such as Ethernet and IEEE 802.5, take the value 'broadcast'.
The OSPF Interface Type will be 'broadcast'.
The OSPF Interface States are: down, loopback, waiting, point-to-point,
designated router, and backup designated router. This is the state of the OSPF
interface.
The IP address representing the designated router.
The IP address representing the backup designated router.
The number of link events.
The cost of the ospf interface. This is a configured value.
202-10009-01
Routing Commands
Advertisement
Table of Contents
