Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
14.5.19.1 no area virtual-link retransmit-interval
This command configures the default retransmit interval for the OSPF virtual interface on
the virtual interface identified by
is the Router ID of the neighbor.
Format
Mode
14.5.20 area virtual-link transmit-delay
This command configures the transmit delay for the OSPF virtual interface on the virtual
interface identified by
Router ID of the neighbor. The range for
Default
Format
Mode
14.5.20.1 no area virtual-link transmit-delay
This command configures the default transmit delay for the OSPF virtual interface on the
virtual interface identified by
the Router ID of the neighbor.
Format
Mode
14.5.21 default-information originate (OSPF)
This command is used to control the advertisement of default routes.
Default
Format
Mode
Routing Commands
and
<areaid>
no area <areaid> virtual-link <neighbor> retrans-
mit-interval
Router OSPF Config
and
<areaid>
<neighbor>
<seconds>
1
area <areaid> virtual-link <neighbor> transmit-
delay <0-3600>
Router OSPF Config
and
<areaid>
<neighbor>
no area <areaid> virtual-link <neighbor> transmit-
delay
Router OSPF Config
metric - unspecified; type - 2
default-information originate [always] [metric <0-
16777215>] [metric-type {1 | 2}]
Router OSPF Config
v1.0, October 2008
. The
<neighbor>
<neighbor>
. The
parameter is the
<neighbor>
is 0 to 3600 (1 hour).
. The
<neighbor>
parameter
parameter is
14-33