Section 4 Settings Required for Basic Control
■ Settings
1
25.0
0.0
0.0
r-s
1
run
1
r-s
stop
4-28
The procedure for stopping control is as follows:
1. Press the M key repeatedly to select "r-s: Run/Stop".
2. Press the U key to switch to "stop: Stop". The STOP indicator blinks and
control stops.
To resume control, follow the same steps to switch to "run: Run". The
STOP indicator goes off and control resumes.
Switching between run and stop is also possible by event
input or communication.
Hint
For event input switching, see "5.7 Using event input" (P.5-
29). For communication switching, see "5.9 Using com-
munication functions" (P.5-34).