Operation Commands (Communication/Compoway/F) - Omron E5AR - MANUAL 2 User Manual

6.7 Operation commands (Communication/CompoWay/F)

Operation commands are sent using the following FINS-mini command text format.
Command
Operation
code
00 Write via
communication
01 Run/Stop
02 Bank change
03 AT run
04 Write mode
05 RAM data save
06 Software reset
07 Move to setting area 1
08 Move to protect level
09 Auto / Manual
0A AT stop
0B Initialize settings
0C Cancel latch
0D SP mode
*1: Operates for all channels.
*2: Specify for each channel
0: CH1, 1: CH2, 2: CH3, 3: CH4, F: All channels
*: A software reset will not respond (no service PDU response).
*: When all channels are specified, only enabled channels will respond and processing will begin from
Channel 1. If an error is detected on any one channel, an "Operation error" will result. If all channels end
normally, "Normal end" results.
When cascade control is selected for the control mode, specify channel 2 commands for
the following operation commands:
• Run/Stop
Important
• Auto / Manual
• SP mode

6.7 Operation commands (Communication/CompoWay/F)

FINS-mini command text
Instruction
MRC SRC
code
"30" "05"
2 2 2
Data name
MRC/SRC
Operation code
Related information
Operation commands for the E5AR/ER are shown in the following.
Description
*1
0
0 to 3, F
0 to 3, F
0 to 3, F
*1
0
*1
0
*1
0
*1
0
*1
0
0 to 3, F
0 to 3, F
*1
0
0 to 3, F
0 to 3, F
Cascade open / closed
Related
information
2
Explanation
Specify the FINS-mini operation command.
Specify an operation code.
Specify information related to the command.
Related information
Higher Byte
0: OFF (Disabled)
1: ON (Enabled)
0: Run 1: Stop
*2
*2 0 to 7: Bank 0 to 7
*2 0: Currently selected PID Set No.
1 to 8: PID Set No.
0: Backup mode
1: RAM write mode
0
0
0
0
*2 0: Auto mode
1: Manual mode
*2 0: Stop
0
*2 0
*2 0: LSP
1: RSP
Lower Byte
6-11